Raceway Support & Hanging, Box Positioning Products

.5"/.75" SNP CLOS COND CLIP 9/16”-3/4” FLAN- 50PK

Conduit flange bottom mount snap close clamps support EMT and rigid conduits from beams. Equipped with a rotatable joint allows the snap-close conduit clip to rotate 360° to position conduits in different directions

Features & Benefits

Hanging and Supports

Snap Close Conduit Clamp pivots 360˚
Bottom or top beam conduit poisoning
Secures EMT, rigid and aluminum conduit to beams
Hammer-On installation

.5”/.75" SM SNAP COND CLIP 9/16”-3/4” FLAN- 100PK

Conduit flange side mount snap close clamps support EMT and rigid conduits from beams. Equipped with a rotatable joint allows the snap-close conduit clip to rotate 360° to position conduits in different directions

Features & Benefits

Hanging and Supports

Snap Close Conduit Clamp pivots 360˚
Side beam conduit poisoning
Secures EMT, rigid and aluminum conduit to beams
Hammer-On installation

1 In. Conduit Hanger With 5/16” To 1/2” Thick Flange Mount

Snap-lock conduit hanger/edge clip hammer-on assemblies are used when EMT or Rigid conduits must be supported below a structural beam

Features & Benefits

Riveted conduit hanger rotates 360 degrees to accommodate various directions of conduit to beam edge
Fits Beam Flange Thickness: 5/16" TO 1/2"
For Conduit Size: 1"

1 EMT Nail Strap

Secures EMT or Rigid/IMC conduit to wood stud or surface

Features & Benefits

Stamped teeth and pointed tip prevent accidental pull out
Zinc plated stamped steel
EMT Size: 1"
Rigid Size: 3/4"

1" ONE HOLE EMT STRAP- 25PK

SouthWire 1" one Hole EMT Strap Indoor or outdoor use to support EMT conduit to wood, masonry or where greater load bearing is required.

Features & Benefits

Hanging and Supports

Snap-on type EMT strap with one hole
Inverted rib for strength
Easy to install

Page updated

Google Sites

Report abuse